| 电动葫芦安全管理制度 |
| 添加时间：2018/10/11 15:34:57 浏览次数： |
| 1. 电动葫芦使用前应检查设备的机械部分和电气部分，钢丝绳、吊钩、导绳器、限位器等应完好，电气部分应无漏电，接地装置应良好。 1. Before using the electric hoist, the mechanical and electrical parts of the equipment should be checked, the wire rope, hook, guide rope, limiter and so on should be in good condition, the electrical part should have no leakage, and the grounding device should be in good condition. 2. 电动葫芦应设缓冲器，轨道两端应设挡板。 2. the electric hoist should have a buffer, and both ends of the track should be provided with baffles. 3. 作业开始第一次吊重物时，应在吊离地面100mm时停止，检查电动葫芦制动情况，确认完好后方可正式作业。制动器应由专业维修人员进行调试。 3. When starting the first lifting of heavy objects, should be lifted off the ground when 100 mm to stop, check the braking condition of electric hoist, to confirm the integrity of the formal operation. The brake shall be adjusted by professional maintenance personnel. 4. 电动葫芦严禁超载起吊，起吊时，手不得握在绳索与物体之间，吊物上升时应严防冲撞。 4. Electric hoist is strictly forbidden to overload the lifting, lifting, hand must not be held between the rope and objects, lifting should be strictly collision-proof. 5. 起吊物件应捆扎牢固。电动葫芦吊重物行走时，重物离地不宜超过1.5m高。工作间歇不得将重物悬挂在空中。 5. lifting objects should be strapped firmly. When the electric hoist is lifting heavy objects, the weight should not exceed 1.5m. No load can be suspended in the air. 6. 电动葫芦作业中发生异味、高温等异常情况，应立即停机检查，排除故障后方可继续使用。 6. Electric hoist in the operation of odor, high temperature and other abnormal circumstances, should immediately stop checking, troubleshooting before continuing to use. 7. 使用悬挂电缆电气控制开关时，绝缘应良好，滑动应自如，人的站立位置后方应有2m空地并应正确操作电钮。 7. When using the electric control switch with suspended cable, the insulation should be good, the sliding should be free, the person's standing position should be 2m space behind and the button should be operated correctly. 8. 在起吊中，由于故障造成重物失控下滑时，必须采取紧急措施，向无人处下放重物。 8. In the course of hoisting, when the heavy objects lose control and slide due to the fault, emergency measures must be taken to drop the heavy objects to the unmanned place. 9. 严禁一人同时操作两台及以上电动葫芦。 9. strictly prohibit one person to operate two or more electric hoists at the same time. 10. 在起吊中不得急速升降。 10. no lifting should be allowed in lifting. 11.电动葫芦在额定载荷制动时，下滑位移量不应大于80mm。否则应清除油污或更换制动环。 11. electric hoist should not exceed 80mm when the rated load is braking. Otherwise, the oil stain should be removed or the brake ring should be replaced. 12.作业完毕后，应停放在指定位置，吊钩升起，并切断电源，锁好开关箱。 12. after the operation is finished, it should be placed in the designated position, the hook will be raised, and the power supply will be cut off and the switch box will be locked. |
| 上一页 电动葫芦的常见故障及处理方法 |
| 下一页 电动葫芦的使用保养 |
Copyright © 技术支持：遨游网络